水力发电学报
            首 页   |   期刊介绍   |   编委会   |   投稿须知   |   下载中心   |   联系我们   |   学术规范   |   编辑部公告   |   English

水力发电学报 ›› 2024, Vol. 43 ›› Issue (9): 94-105.doi: 10.11660/slfdxb.20240909

• • 上一篇    下一篇

针片状骨料含量对沥青混凝土骨料级配的影响研究

  

  • 出版日期:2024-09-25 发布日期:2024-09-25

Influence of needle-shaped flake aggregate content on asphalt concrete aggregate gradation

  • Online:2024-09-25 Published:2024-09-25

摘要: 为研究针片状骨料含量对沥青混凝土骨料级配的影响,本文采用逐级填充法,选用骨架稳定性为衡量骨架级配优劣的唯一指标,考虑针片状含量为0%、20%、25%、30%、35%,利用垂直振动压实仪成型试件。结合加州承载比(CBR)值、骨架密度与空隙率综合评价骨架稳定性,以此确定各组粗骨料级配。采用合成级配的设计方法,将粗细集料进行全粒径骨料级配设计。结果表明,随着针片状骨料含量的增加,全粒径骨料骨架稳定性呈现先增后减的趋势,其中针片状骨料含量为30%的骨架稳定性最优,针片状骨料含量35%的稳定性最劣。

关键词: 水工沥青混凝土, 针片状骨料, 骨料级配, 垂直振动压实, CBR指标

Abstract: This study examines the influence of needle flake aggregate content on the gradation of asphalt concrete aggregate, using a stepwise filling method and adopting skeletal stability as the sole criterion for assessing the quality of aggregate skeleton. A vertical vibration compaction device is used to prepare the specimens with needle flake contents of 0%, 20%, 25%, 30%, and 35%, respectively; Skeletal stability is evaluated comprehensively by combining the California bearing ratio (CBR) value, skeletal density, and porosity to determine the coarse aggregate gradation for different specimen sets. Aggregate gradation is designed using a composite gradation design method through blending coarse and fine fractions across the full-size range. The findings indicate that with an increasing content of needle-like aggregates, the stability of aggregate skeleton takes a trend of initial increase and then decrease. The optimal stability is observed at a needle flake content of 30%, while the least favorable is at the content of 35%.

Key words: hydraulic asphalt concrete, needle-shaped flake aggregate, aggregate gradation, vertical vibration compaction, CBR index

京ICP备13015787号-3
版权所有 © 2013《水力发电学报》编辑部
编辑部地址:中国北京清华大学水电工程系 邮政编码:100084 电话:010-62783813
本系统由北京玛格泰克科技发展有限公司设计开发  技术支持:support@magtech.com.cn